HYDROS Control Power Supply w/ Terminator
$ 25.97
- HYDROS Control Power Supply (w/ Terminator) - Power Up The HYDROS Control Power Supply (w/ Terminator) ensures your HYDROS brain stays online, steady, and safe. Designed for lower-power HYDROS controllers, this compact unit includes a pre-installed terminator—so you can skip the guesswork and plug directly into performance. HYDROS Control Power Supply (w/ Terminator) – Tailored for Smaller Controllers Not all HYDROS devices need a high-output power brick. This 1 Amp low-capacity supply accessory delivers reliable energy without overshooting the mark, keeping your core modules humming without risking overload. Compatible With: HYDROS Control XS HYDROS Control X2 HYDROS Control X3 HYDROS Control X4 HYDROS Minnow Note: This supply is ideal for HYDROS Collectives using Data-Only Cables—especially setups without an available command bus port. Control Power Supply (w/ Terminator) – What Makes It Different? This isn't your average plug-and-play cord. With the HYDROS Terminator already installed, you gain proper voltage regulation and system termination in one move. It’s designed to support communication stability in your reef control loop—no signal noise, no boot issues, just clean power. Not Compatible With: HYDROS WaveEngine (V1, V2, LE) IceCap Dual Pump Controller High-draw HYDROS units like X10 or Kraken If your setup includes larger components, you’ll want to check out the 4 Amp or 6.35 Amp models instead. Key Specs for the Control Power Supply (w/ Terminator) Capacity: 1 Amp Includes: Pre-installed HYDROS Terminator Intended Use: Low-draw HYDROS Controls, especially within Collectives Voltage Regulation: Clean and consistent for data-dependent modules Plug Type: U.S. Standard AC